APPLICATIONS :
Designed specifically for industries where a high degree of filtering efficiency is essential. The construction of the element ideally meets the design requirement of today's variable air volume systems. Being totally rigid, filter performance is neither interrupted by changes in air 

velocity nor fan shut down. The MECHFIL DRY FABRIC Filter is designed for use in those areas requiring the highest degree of air cleanliness. Used in wide variety of applications including Operation Theatres, Pharmaceuticals, Petrochemicals, Fertilizers, Computer Installations, Nuclear Energy, Industrial Facilities and virtually all areas where clean air is critical.

 CONSTRUCTION :  
The filter element is constructed from special pressed felt filter fabric, stitched on into G.I. wire gauze support. Crimping into deep folds increases relative filtration area resulting in low differential pressure, high dust retention capacity, high flow rate.
To ensure uniform distribution of Air Flow and longer service life, filter folds are separated by aluminium spacers.  

PERFORMANCE
MECHFIL ADA
series ensure relative low velocity and consistent efficiency rating of 99% for particles down to 5 microns. Tested as per B.S.2831/1701 as per Test Dust No.2.

OPERATING CONDITIONS :
Can be used under conditions of high relative humidity. Recommended that the filter element can be replaced every 12-18 months. It has a good capacity of holding dust.

INSTALLATION
May be mounted in multiple Banks on angle iron frames for large volumes of air flow. 




MECHFIL DRY FABRIC SELECTION
( EFFICIENCY 99% down to 5 microns ) ADA SERIES


Mechfil
Series

Dimensions

Filtration 
Area

Capacity at
6.5 mm
W.G.

Approx.
Weight


Inches

Sq. ft.

C.F.M.

Kgs.


ADA-1

24" x 24" x 12"

105.0 2000 16.5
ADA-2 24" x 24" x 06" 55.0 1015 10.7
ADA-3  20" x 20" x 06" 40.0 700 8.0
ADA-4 20" x 15" x 06" 28.0 520 7.0
ADA-5 24" x 24" x 02" 18.5 340 4.0
ADA-6 25" x 20" x 02" 16.5 300 3.5
ADA-7 20" x 20" x 02" 13.5 240 3.0
ADA-8 25" x 16" x 02" 12.0 220 2.8

NOTE: Series 1, 2, 3 & 4 are Flange type (inclusive of Flanges). Series 5, 6, 7 & 8 are Channel Mounting type (Slip-on).
Sizes as per specifications  other than above shall be fabricated separately. 







HOME | ABOUT US | PRODUCTS | CONTACT US
FILTRATION SYSTEMS & PROJECTS | OUR ESTEEMED CLIENTS | TESTING & CERTIFICATION


Copyright 2000 UCCO-MECH FILTERS Pvt. Ltd.
All rights reserved.